Table of Contents
Advertisement
1-16
19. Set the Power switch to On. (This causes the print
head to move.)
After approximately 5 seconds, the following lights should be the only
lights on:
•
Power On
•
Data Cleared (7)
•
Transparent Mode (8)
These lights should be on if there is power at the outlet, the paper is
loaded properly, the tape securing the print head has been removed, and
the print head can be manually moved.
20. Press each of the following switches to make sure
the forms are properly installed and the paper is
feeding properly.
Form
Feed
Line
Feed
~
Start
Stop
~
Normally advances the paper one line each time. you press this
switch, unless the number of lines advanced is changed by
the host program.
Advances the paper one line each time you press this switch.
Causes the Ready light to turn on and the print head to move.
Causes the Ready light to turn off and the print head to move to the left
margin area.
Advertisement
Table of Contents
