Removing The Thermistor And The Thermal Cutout - Kyocera FS-1800 Service Manual

(4) Removing the thermistor and the thermal cutout

1. Remove and split the fuser unit. See page 5-29.
2. Remove the heater lamp. See page 5-33.
3. Remove the heat roller. See previous page.
4. Remove one screw 1.
5. Remove the thermistor 2.
6. Remove two screws 3 and then remove cord plate 4.
7. Remove one screw 5 and the heater wire terminal 6.
8. Remove the thermal cutout 7.
Figure 5-2-32 Removing the thermistor and thermal cutout
3
4
5
6
7
2
FS-1800/1800N | FS-3800/3800N
5-35
1