Maintenance - Stanley STDR5510 Original Instructions Manual

ENGLISH
Warning! To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Drilling in metal
Start drilling with slow speed and increase to full power while
applying firm pressure on the tool. A smooth even flow of
metal chips indicates the proper drilling rate. Use a cutting
lubricant when drilling metals. The exceptions are cast iron
and brass which should be drilled dry.
Note: Large [5/16" (8 mm)] holes in steel can be made
easier if a pilot hole [5/32" (4 mm)] is drilled first.
Drilling in wood
Start drilling with slow speed and increase to full power while
applying firm pressure on the tool. Holes in wood can be
made with the same twist drills used for metal. These bits
may overheat unless pulled out frequently to clear chips
from the flutes. Work that is apt to splinter should be backed
up with a block of wood.
Accessories
The performance of your tool depends on the accessory
used.STANLEY accessories are engineered to high quality
standards and designed to enhance the performance of your
tool. By using these accessories you willget the very best
from your tool.

Maintenance

Your tool has been designed to operate over a long period of
time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! Before performing any maintenance, switch off
and unplug the tool.
• Regularly clean the ventilation slots in your tool using a
soft brush or dry cloth.
• Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
Remarks
• STANLEY's policy is one of continuous improvement to
our products and as such, we reserve the right to modify
product specifications without prior notice.
• Standard equipment and accessories may vary by
country.
• Product specifications may differ by country.
• Complete product range may not be available in all
countries. Contact your local STANLEY dealers for range
availability.
6
(Original instructions)
Technical data
POWER W
VOLTAGE V
FREQUENCY Hz
NO-LOAD SPEED /min
REVERSE
LOCK ON
MAX DRILLING CAPACITY
STEEL mm
WOOD mm
CHUCK CAPACITY mm
STDR5510
550
220-240
50/60
0-2800
YES
YES
10
25
1.5-10