Remote Keyless Entry Transmitter - Dodge Dakota Sport 2001 Service Manual

AN
POWER LOCK SWITCH (Continued)
Fig. 5 Power Lock Switch Connector Receptacle
POWER LOCK SWITCH TEST
SWITCH POSITION
NEUTRAL
LOCK
UNLOCK
REMOVAL
The power lock switch on the driver side front door
trim panel is integral to the driver door module.
(Refer to 8 - ELECTRICAL/POWER LOCKS/DRIVER
DOOR MODULE - REMOVAL).
(1) Disconnect and isolate the battery negative
cable.
(2) Using a trim stick or another suitable wide flat
bladed tool and starting at the rear of the passenger
door power window and lock switch bezel, gently pry
the bezel up and out from the passenger side front
door trim panel.
(3) Pull the power window and lock switch bezel
away from the trim panel opening far enough to
access the two switch connector receptacles on the
back of the unit.
(4) Disconnect the door wire harness connectors
for the power lock and power window switches from
the switch connector receptacles.
(5) Remove the power window and lock switch
bezel from the door trim panel.
RESISTANCE BETWEEN
PINS 1 & 5
10 KILOHMS ±1%
820 OHMS ±1%
330 OHMS ±1%
(6) Using a small thin-bladed screwdriver, gently
pry the snap clips at the sides of the power lock
switch receptacle on the back of the power window
and lock switch bezel and pull the switch out of the
receptacle.
INSTALLATION
The power lock switch on the driver side front door
trim panel is integral to the driver door module.
(Refer to 8 - ELECTRICAL/POWER LOCKS/DRIVER
DOOR MODULE - INSTALLATION).
(1) Align the power lock switch with the receptacle
on the back of the power window and lock switch
bezel.
(2) Using hand pressure, gently and evenly press
down on the power lock switch it snaps into place in
the power window and lock switch bezel receptacle.
(3) Position the power window and lock switch
bezel to the opening in the passenger side front door
trim panel.
(4) Reconnect the two door wire harness connec-
tors for the power window and power lock switches to
the switch connector receptacles.
(5) Insert the front of the power window and lock
switch bezel into the opening in the passenger side
front door trim panel.
(6) Using hand pressure, gently and evenly press
down on the rear of the power window and lock
switch bezel until it snaps into place.
(7) Reconnect the battery negative cable.
REMOTE KEYLESS ENTRY
TRANSMITTER
DESCRIPTION
The Remote Keyless Entry (RKE) system Radio
Frequency (RF) transmitter is equipped with three
buttons, labeled Lock, Unlock, and Panic. It is also
equipped with a key ring and is designed to serve as
a key fob. The operating range of the transmitter
radio signal is up to 7 meters (23 feet) from the RKE
receiver. The RKE receiver is integral to the Central
Timer Module (CTM) in this vehicle.
Each RKE transmitter has a different vehicle
access code, which must be programmed into the
memory of the RKE receiver in the vehicle in order
to operate the RKE system. The RKE receiver can
retain the access codes for up to four transmitters in
its memory. (Refer to 8 - ELECTRICAL/POWER
LOCKS/REMOTE KEYLESS ENTRY TRANSMIT-
TER - STANDARD PROCEDURE - RKE TRANS-
MITTER PROGRAMMING).
The RKE transmitter operates on two Duracell
DL2016, Panasonic CR2016 (or equivalent) batteries.
Typical battery life is from one to two years. The
POWER LOCKS 8N - 11