Fog Lamp - Dodge Dakota Sport 2001 Service Manual

AN

FOG LAMP

REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Disengage fog lamp harness connector.
(3) Rotate bulb socket a 1/4 turn counterclockwise
and pull from lamp to separate (Fig. 5).
(4) Grasp bulb and pull from lamp.
Fig. 5 Fog Lamp Bulb
1 - FOG LAMP
2 - FOG LAMP BULB
INSTALLATION
CAUTION: Do not touch the bulb glass with fingers
or other oily surfaces. Reduced bulb life will result.
(1) Position bulb in lamp, push to seat and rotate
a 1/4 turn clockwise.
(2) Connect fog lamp harness connector.
(3) Connect the battery negative cable.
LAMPS/LIGHTING - EXTERIOR
FOG LAMP UNIT
REMOVAL
NOTE: The fog lamps are serviced from the rear-
ward side of the front bumper.
(1) Disconnect and isolate the battery negative
cable.
(2) Disengage fog lamp harness connector.
(3) Remove the bolts attaching the fog lamp to the
bumper (Fig. 6).
(4) Separate fog lamp from bumper.
Fig. 6 Fog Lamp
1 - FOG LAMP
2 - FRONT BUMPER
INSTALLATION
(1) Position fog lamp in bumper.
(2) Install the bolts attaching the fog lamp to the
bumper.
(3) Connect fog lamp harness connector.
(4) Check for proper operation and beam align-
ment.
(5) Connect the battery negative cable.
ADJUSTMENTS - FOG LAMP UNIT
Prepare an alignment screen. (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - ADJUSTMENTS). A properly aligned
fog lamp will project a pattern on the alignment
screen 100 mm (4 in.) below the fog lamp centerline
and straight ahead (Fig. 7). Rotate the adjustment
screw to adjust beam height (Fig. 8).
8L - 13
- EXTERIOR/HEAD-