Reading Lamp - Dodge Dakota Sport 2001 Service Manual

8L - 28 LAMPS/LIGHTING - INTERIOR
GLOVE BOX LAMP SWITCH (Continued)
(5) Pull the glove box lamp and switch out from
the mounting hole far enough to access the wire har-
ness connector.
(6) Disconnect the instrument panel wire harness
connector from the glove box lamp and switch con-
nector receptacle.
(7) Remove the glove box lamp and switch from
the instrument panel.
INSTALLATION
WARNING: ON VEHICLES EQUIPPED WITH AIR-
BAGS, REFER TO
BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL
COMPONENT DIAGNOSIS OR SERVICE. FAILURE
TO TAKE THE PROPER PRECAUTIONS COULD
RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND POSSIBLE PERSONAL INJURY.
(1) Position the glove box lamp and switch to the
instrument panel.
(2) Reconnect the instrument panel wire harness
connector to the glove box lamp and switch connector
receptacle.
(3) Feed the instrument panel wire harness back
into the glove box lamp and switch mounting hole in
the glove box opening upper reinforcement.
ELECTRICAL, RESTRAINTS
(4) Align the glove box lamp and switch housing
with the mounting hole in the instrument panel
glove box opening upper reinforcement.
(5) Push the glove box lamp and switch into the
mounting hole in the instrument panel glove box
opening upper reinforcement until the retaining
latches are fully engaged.
(6) Close the glove box.
(7) Connect the battery negative cable.

READING LAMP

REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) From the center of the lens outward, pry the
lens from the overhead console.
(3) Remove bulb.
INSTALLATION
(1) Install bulb.
(2) Snap lens into position.
(3) Connect the battery negative cable.
AN