Rear Bumper - Dodge Dakota Sport 2001 Service Manual

13 - 2 FRAME & BUMPERS
FRONT BUMPER (Continued)
1 - FOG LAMP
2 - FRONT BUMPER
3 - OUTER BUMPER BRACKET
4 - U-NUT
INSTALLATION
When the front bumper is installed, there should
be a 19 mm gap between the bumper and front
fender.
(1) Place the bumper on a suitable lifting device
and position the bumper at the vehicle.
(2) Install the bolts attaching front bumper to
inner bumper bracket. Tighten to 94 N·m (70 ft. lbs.)
torque.
(3) Install the bolts attaching outer bumper brack-
ets to the frame rail. Tighten to 94 N·m (70 ft. lbs.)
torque. Ensure front wheelhouse liners are positioned
correctly behind bumper.
(4) Engage wire connectors to fog lamps, if
equipped.
(5) Install push-in fasteners attaching air deflector
to front bumper fascia.
(6) Remove lifting device.
(7) Close hood.
Fig. 1 Front Bumper
5 - FRAME
6 - INNER BUMPER BRACKET
7 - FASCIA BRACKET
FRONT FASCIA
REMOVAL
(1) Remove the front bumper.
(2) Remove the bolts attaching the fascia to the
bumper.
(3) Separate fascia from bumper.
INSTALLATION
(1) Position fascia on bumper.
(2) Install the bolts attaching the fascia to the
bumper.
(3) Install the front bumper.

REAR BUMPER

REMOVAL
(1) Support rear bumper on a suitable lifting
device.
(2) Remove bolts attaching inner bumper brackets
to frame rails (Fig. 2).
AN