Table of Contents
Advertisement
➀
3. Insert the tongue plate (
➁
open end of the buckle (
audible "click" is heard, indicating
the belt is locked in the buckle.
1GHA2263
) into the
4. Position the lap portion (
) until an
belt across your lap as LOW ON
THE HIPS as possible to reduce
the risk of sliding under it during
an accident. Adjust the belt to a
SNUG FIT by pulling up on the
shoulder portion (
belt. The belt retractor is designed
to take up excess webbing auto-
matically and to maintain tension
on the belt. For your safety, do not
put any excess slack into the safe-
ty belt at any location.
1GHA2264
➀
5. Adjust the shoulder anchor posi-
) of the
tion to your size. To raise the
anchor position, push the anchor
➀
up (
tion, press (
slide the anchor down (
➁
adjustment, make sure the anchor
) of the safety
is locked in position.
If the height of the adjusting seat belt
is too near your neck, you will not be
getting the most effective protection.
The shoulder portion should be
adjusted so that it lies across your
chest and midway over your shoulder
nearest the door and not your neck.
Knowing your vehicle
1KMA2050
). To lower the anchor posi-
➁
) the button ( ) and
A
➂
). After
3 37
1
2
3
4
5
6
7
8
9
Advertisement
Table of Contents
