Table of Contents
Advertisement
Driving tips
Programming
Your vehicle may require the ignition
switch to be turned to the ACC posi-
1
tion for programming and/or opera-
tion of HomeLink. It is also recom-
2
mended that a new battery be
replaced in the hand-held transmitter
of the device being programmed to
3
HomeLink for quicker training and
accurate transmission of the radio-
frequency.
4
Follow these steps to train your
HomeLink mirror:
5
6
7
8
9
5
46
Flashing
1. When programming the buttons
for the first time, press and hold
the left and center buttons (
) simultaniously until the
indicator light begins to flash after
approximately 20 seconds. (This
procedure erases the factory-set
default codes. Do Not perform this
step to program additional hand-
held transmitters.)
✽ NOTICE
For non rolling code garage door
openers, follow steps 2 - 3.
For rolling code garage door open-
ers, follow steps 2 - 6.
For Canadian Programming, please
follow the Canadian Programming
section.
For help with determining whether
your garage is non-rolling code or
MMSA5005
rolling code, please refer to the
garage door openers owner's manu-
al or contact HomeLink customer
,
service at 1-800-355-3515.
Advertisement
Table of Contents
