Driving tips
6. Return to the vehicle and firmly
press
and
release
grammed HomeLink button up to
1
three times. The rolling code
equipped device should now rec-
ognize the HomeLink signal and
2
activate when the HomeLink but-
ton is pressed. The remaining two
buttons may now be programmed
3
if this has not previously been
done. Refer to the "Programming"
4
portion of this text.
5
6
7
8
9
5
48
Operating HomeLink
the
pro-
To operate, simply press the pro-
grammed
Activation will now occur for the
trained product (garage door, securi-
ty system, entry door lock, estate
gate, or home or office lighting). For
convenience, the hand-held trans-
mitter of the device may also be used
at any time. The HomeLink Wireless
Controls System (once programmed)
or the original hand-held transmitter
may be used to activate the device
(e.g. garage door, entry door lock,
etc.). In the event that there are still
programming difficulties, contact
HomeLink at 1-800-355-3515 or on
the internet at www.homelink.com.
HomeLink
button.
Erasing programmed
HomeLink buttons
To erase the three programmed but-
tons (individual buttons cannot be
erased):
• Press and hold the left and center
HomeLink is now in the train (or
learning) mode and can be pro-
grammed at any time.
Flashing
MMSA5005
buttons simultaniously, until the
indicator light begins to flash
(approximately
20
seconds).
Release both buttons. Do not hold
for longer than 30 seconds.