Silicon Laboratories c8051f33x User Manual page 11

D C
OCUMENT HANGE
Revision 0.4 to Revision 0.5
 Section 1, added USB Debug Adapter and USB Cable.
 Section 2, changed name from "Hardware Setup" to "Hardware Setup using an EC2 Serial Adapter".
 Section 2, added 2 Notes bullets.
 Section 2, removed Note from bottom of page.
 Added Section 3, "Hardware Setup using a USB Debug Adapter".
 Section 5.4.2, changed step 2 to include new instructions.

Section 7, J4, changed "Serial Adapter" to "Debug Adapter".
 Target Board DEBUG Interface Section, added USB Debug Adapter.
 DEBUG Connector Pin Descriptions Table, changed pin 4 to C2D.
 Changed "jumper" to "header".
 EC2 Serial Adapter section, added EC2 to the section title, table title and figure title.
 EC2 Serial Adapter section, changed "JTAG" to "DEBUG".
 Added "USB Debug Adapter" section.
 Section 7, J8, changed "Serial Adapter" to "USB Debug Adapter"
 DEBUG Connector Pin Descriptions Table, changed pin 10 to USB Power
 USB Debug Adapter Target Board Power Connector (J8) Section, changed "Serial" to "USB Debug"
Revision 0.5 to Revision 0.6
 Removed EC2 Serial Adapter from Kit Contents.
 Removed Section 2. Hardware Setup using an EC2 Serial Adapter. See RS232 Serial Adapter (EC2)
User's Guide.
 Removed Section 8. EC2 Serial Adapter. See RS232 Serial Adapter (EC2) User's Guide.
 Removed Section 9. USB Debug Adapter. See USB Debug Adapter User's Guide.
Revision 0.6 to Revision 0.7
 Updated 3. "Software Setup‚" on page 2.
L
IST
Rev. 0.7
C8051F33x
11