Usage; Repair And Maintenance - Razor Pocket Mod Owner's Manual

USAGE

Starting the Pocket Mod
Place both hands on the handlebars. Slowly push forward with
one foot and apply the throttle.
Note: Keep both feet on the base fairing when unit is in motion.

REPAIR AND MAINTENANCE

Turn power "OFF" before conducting any maintenance procedures.
Testing the Brake
To use the brake, squeeze the lever to increase the pressure on the brake. The brake lever is fitted with a cable
adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not
engaging properly, follow instructions for adjusting the brakes.
Adjusting the Brake
Tools required: 10 mm wrench
1
To adjust the tension, thread the brake lever adjuster on
the hand brake in or out 1/4 to 1/2 turn until the desired brake
adjustment is attained. Most adjustments are complete at this
step. If brake still needs further adjustment, proceed to step 2.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Stopping the Pocket Mod
Release the throttle and apply the brake.
Note: When coming to a complete stop, place both feet on the
ground to balance the unit.
2
If brake is too tight or has too much slack,
use a 10 mm wrench to loosen the nut for
additional adjustment on the brake cable on the
rear wheel. Securely tighten nut when done.
8
WARNING: The brake is
capable of skidding the tire and
throwing an unsuspecting rider.
Practice in an open area, free from
obstacles, until you are familiar with
the brake function. Avoid skidding to
a stop as this can cause you to lose
control or damage the rear tire.
Note: The brake lever contains a
safety switch to cut power to the
motor when the brake is applied. In
an emergency, applying the brake
will always stop the product from
moving. Do not disable or replace
this lever with anything other than a
genuine Razor replacement part.