Before You Begin - Razor Pocket Mod Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Pocket Mod is 95 percent assembled and packed at the factory, there should not be any problems, even if
the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 15 minutes for assembly.
Allow up to 12 hours for initial charge (see page 7 for charging information).
Brake Lever
Throttle
On/Off
Switch
Charger Port
3. Charger
(Note: Charger design may vary
from one shown)
Required Tools
5 mm and 6 mm
Allen Wrenches
(Included)
2. Underneath Frame
1. Storage Compartment
Under Seat
Chain Guard
Two (2) 13 mm/15 mm
Wrenches
(Included)
Kick Stand
Spoke Tightener
(Included)
3
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR RAZOR
POCKET MOD.
The Pocket Mod has been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void your
warranty.
Product I.D. Code:
1. Inside Storage Compartment
2. Underneath Frame
3. Charger
4. UPC Side of Box (not shown)
Plastic Bag Contents:
• Charger
• Tools
• Owner's Manual