Rinse Sentry Mode - Champion UH330 ADA Installation & Operation Manual

Operation
Operation
Wash Mode
(continued)
The HEAVY cycle is selected by pushing the cycle button twice. The HEAVY green
9.
indicator light will flash for 15 seconds. Pressing the START button before the flashing
HEAVY indicator light stops flashing starts the heavy wash cycle of approximately 4-1/2
minutes long. The HEAVY green indicator light will come on and the green indicator light
above the start switch will illuminate indicating the machine is in the wash mode.
10. Opening the door during a cycle will stop the dishwasher. The cycle will resume
automatically if the dishwasher door is closed within 5 seconds. If the door is open for
more than 5 seconds the cycle will start from the beginning of the cycle.
11. The final rinse cycle begins at the end of the wash cycle. The machine drains and
retains a portion of the final rinse water for the next wash cycle.
12. Check the rinse temperature gauge during the final rinse. It must indicate a minimum of
180-195ºF/82-91ºC. The final rinse water is retained for the next wash cycle.
13. When the green cycle light goes out, open the door and remove the rack of clean wares.
If the dishwasher door is left open for more than 5 seconds during the wash mode
the dishwasher cycle will reset to the beginning of the selected wash cycle.

Rinse Sentry Mode

RINSE SENTRY MODE WILL EXTEND WASH CYCLE TIME
In the event that the final rinse temperature inside the booster tank has not reached
180-195ºF/82-91ºC after the wash cycle, the rinse sentry will extend the wash cycle time until
the booster reaches 180-195ºF/82-91ºC. If the proper temperature is not reached within 5
minutes, the machine will leave the rinse sentry mode and complete the cycle.
20
! ATTENTION !
DOOR LEFT OPEN DURING WASH CYCLE
! ATTENTION !