Champion UH330 ADA Installation & Operation Manual page 13

Connecting Incoming Power to the Main Terminal Block
for 1PH and 3PH
Refer to the photo below:
4. Provide a 3 foot/1 meter service loop in the power supply cable to service the machine
5. Route the power cable from the rear of the machine to the terminal block making sure
the cable does not touch the booster heater.
6. Connect the power cable to the terminal block bracket using a suitable strain relief
connector.
7. Connect the power wires according to the wiring diagrams for either single phase or
three phase operation.
8. Return the main terminal block bracket to its original position making sure the power
cable does not touch the booster tank. Install the retaining screws.
9. Swing the chemical pump bracket and the chemical board back into position and
secure with the existing fasteners.
Main Terminal Block Cover
Installation
Main Terminal Block
5