Control Panel And Wash Mode - Champion UH330 ADA Installation & Operation Manual

Operation
UH330 ADA Control Panel
The illustration below shows the operator controls and temperature displays for the UH330 ADA.
ON
OFF/DRAIN
POWER
Wash Temperature
ON-OFF/DRAIN
Power Switch
Wash Mode
Close the door.
1.
Push the dishwasher ON-OFF/DRAIN switch UP to turn the power ON.
2.
The power switch will illuminate and the machine will fill with water. The cycle light
3.
flashes during the fill cycle.
Wait approximately 30 minutes until the wash temperature gauge indicates a minimum of
4.
150ºF/66ºC.
Scrap the wares to remove large food particles.
5.
Load the dish rack into the machine. Wash one dish rack at a time.
6.
NORMAL
HEAVY
CYCLE
7. The NORMAL cycle setting is the default cycle and does not have a green indicator light.
The normal cycle is approximately 2-1/2 minutes long.
8. The EXTRA cycle is selected by pushing the cycle button once. The EXTRA green indicator
light will flash for 15 seconds. Pressing the START button before the flashing EXTRA ind-
icator stops flashing starts an EXTRA wash cycle of approximately 2 minutes. The EXTRA
green indicator light will come on. and the green indicator light above the start switch will
illuminate indicating the machine is in the wash mode.
WASH
Digital Display
Final Rinse Temperature
Digital Display
EXTRA
START
TEMPERATURE
DETERGENT
RINSE RINSE AID
PRIME
Prime
Push button
Cycle Selector
Push button
Push the Cycle button once for Extra Cycle.
Push twice for Heavy Cycle.
Push the Cycle button three times to cancel
the selection and return to Normal Cycle.
Operation
NORMAL
EXTRA
HEAVY
CYCLE START
Start
Time Select
Push button
Lights
Cycle Light
19