Champion UH330 ADA Installation & Operation Manual page 24

Installation
Detergent and Rinse-aid Dispensing Pump Adjustments
Chemical Dispensing Pump Adjustments (
THE FILL AND SANITIZER ADJUSTMENT SCREWS ARE NOT USED ON THE
Refer to the photo below:
To adjust the amount of chemicals dispensed
by the pumps:
1. Make sure the chemical containers are full and
the pick-up tubes are in their proper containers.
3. Turn the dishwasher power switch ON.
The switch will illuminate and the dishwasher
will fill with water.
4. Run a normal dishwasher cycle and test
detergent and rinse-aid concentrations
according to the chemical supplier's
instructions.
CAUTION:
Excessive pressure to the potentiometers when
adjusting can result in bent or broken adjusting
screws.
5. Each dispensing pump has a clearly marked
adjustment screw. Turn the screw CW to
increase the run time of the dispensing pump
and CCW to reduce the run time.
16
continued)
! ATTENTION !
UH330 ADA MACHINE.
Use a 4mm
blade
screwdriver