Finishing; Facing Material; Mantel And Wall Projections - Majestic MERC32VN Installation Manual

10 10

Finishing

A. Facing Material
• Metal front faces may be covered with non-combustible
materials only.
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers, operation of louvers or doors,
or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
• Seal joints between the fi nished wall and appliance top
using a 300 ºF minimum sealant. Refer to Figure 10.2.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of doors and louvers.
0 IN.
Figure 10.1 Non-combustible Facing Diagram
48 Majestic • MERC32IN, MERC32IL, MERC32VN, MERC32VL Installation Manual • 2401-980 Rev. C • 11/16
B. Mantel and Wall Projections
WARNING! Risk of Fire! Comply with all minimum clear-
ances as specifi ed. Framing closer than the minimums list-
ed must be constructed entirely of non-combustible materi-
als (i.e., steel studs, concrete board, etc.).
Note: Measurement is taken from top of the
opening, NOT the top of the fi replace.
Combustible or Non-Combustible Mantels
0 IN.
0 IN.
Figure 10.2
Note: All
measurements
in inches.
10
9
8
7
6
5
4
3
6
5
4
TOP OF HOOD OR FIREPLACE OPENING
MEASUREMENTS FROM
TOP EDGE OF THE OPENING
See Dimension V on Appliance
Dimension Diagram
(Figure 3.1)
Clearances To Combustibles Mantels Or Other
Combustibles
CEILING
12
11
32
13
12
11
10
9
8
7