System Diagram; Group Control - Fujitsu AUXG18LRLB Technical Manual

 Backlit LCD
 System diagram
1 remote controller
Indoor unit
A
Remote controller
NOTE: Multiple installation method described above is prohibited to combine with 2-wired type
and 3-wired type.
 Group control
With a single remote controller, up to 16 units can be simultaneously operated.
A, B, C, D, E : Remote controller cable. (Refer to Chapter 2-4.
10.)
A+B+C+D+E ≤ 500 m.
CAUTION
!
Group control is only possible between units with remote controllers of the same type.
After confirming that the connected remote controllers have same model name by checking
the rear side of the remote controller or "Chapter 13-1.
the group control.
• The backlit LCD enables easy operation in a dark room.
• Backlighting time can be selected from 30 or 60 seconds.
• The backlight is lit while the buttons are operated, and goes off 30 or
60 seconds after the operation stops.
2 remote controllers
Indoor unit
B C
Master Slave
Remote controllers
I.U.: Indoor Unit
I.U. I.U.
B C D
A
Master
- 8 -
A, B, C: Remote controller cable
A≤ 500 m; B+C≤ 500 m
I.U. I.U.
E
"Wiring specifications"
"Controllers" on page 77", perform
on page