Quick Setup Guide - Sharp UX-340L Service Manual

UX-340L
(TCADZ2890XHZZ)
UX-345L
(TCADZ2893XHZZ)
UX-330L
(TCADZ2964XHZZ)

[6]Quick Setup Guide

Be sure to perform each step in the
order indicated.
Note: For detailed instructions, refer to
the indicated pages of the operation
manual.
5
Load the imaging film.
1. Open the operation panel and then pull the green release
forward to open the print compartment cover.
4. Insert the large gear into the large holder 5. Cut the band that holds the two spools
on the imaging film cartridge, and then together. Unroll the film slightly and
insert the small gear on the other end of insert the small gears into their holders.
the spool into its holder.
1 2
Connect the handset and place it
on the handset rest.
6. Turn the cartridge over and insert it
into the print compartment.
3
Plug the power cord into a 120 Connect the telephone line
V, 60 Hz, grounded (3-prong) AC cord to the TEL. LINE jack
outlet. and a wall telephone jack.
Note: To connect an answering machine
to the fax. To connect an extension
phone.
2. Remove the roll of imaging film from its
packaging. (Note: Do not yet remove the band
that holds the rolls together.)
Pull the spools
apart slightly to
allow the gears to
fit in.
7. Rotate the large gear toward you until 8. Close the print compartment cover (press down on both sides to make
the film is taut. sure it clicks into place), and then close the operation panel.
4
Attach the supports.
Note: If the
support doesn't
go in, turn it over.
3. Insert the large gear into the green end of the
empty spool. Insert the remaining three gears
into the ends of the spools. (Make sure the
protrusions on the gears fit into the slots in the
spool ends.)
IMPORTANT: Do NOT discard green gears. They
are not included with replacement imaging film.
Large gear