Installing The Hard Disk Drive - Fujitsu ST4000 Technical Reference Manual

Hide thumbs Also See for ST4000:
Table of Contents

Advertisement

4. Using your thumbs, push up the two tabs on the outside edge of the hard disk drive (at the locations indicated in
Figure A-3) Lift the drive out of the system.
5. Once the hard disk drive has been removed from the Tablet PC, you can install a new hard disk drive. If you are
returning the hard disk drive for repair, ensure that the packaging material will protect the drive sufficiently
during shipment.

Installing the Hard Disk Drive

To install the hard disk drive, refer to Figures A-1 through A-3, and perform the following steps:
1. Insert the hard disk drive into the Tablet PC.
2. Follow the steps contained in the section entitled "Removing the Hard Disk Drive" in reverse order. Use care
when installing the drive to prevent damage to the flex cable.
The hard disk drive is now installed in the Tablet PC.
Figure A-2 Unplugging the Hard Disk Drive Connector
Figure A-3 Removing the Hard Disk Drive
Connector
Plug
Installing the Hard Disk Drive
6
54

Advertisement

Table of Contents
loading

Table of Contents