Advertisement
FIGURE 4
STEP 4:
• Insert two GUIDE RODS (18) into the BASE (1) as shown on FIGURE 4. (NOTE: If the 777 SHROUD OPTION was pur-
chased, place the GUIDE RODS (18) through the BOTTOM SHROUD BRACKET (71) and into the BASE (1) as shown
in FIGURE 4.
•
(NOTE: Lubricate GUIDE RODS (18) with silicon or teflon spray available at most hardware stores.)
• Slide two WEIGHT STACK SPACERS (33), two 3/4" FLAT WASHERS (34), and two WEIGHT STACK CUSHIONS (28) down
over the GUIDE RODS (18).
• Using EXTREME CARE slide all fifteen WEIGHT PLATES (21) down over the GUIDE RODS (18) on to the WEIGHT STACK
CUSHIONS (28). Make sure that the WEIGHT PLATES (21) are all facing as shown.
• Slide the head plate assembly down over the GUIDE RODS (18) onto the weight stack.
• Slide two SHAFT COLLARS (36) over the GUIDE RODS (18) as shown in FIGURE 4.
1/2
0
1/2
1/2
1
2
1/2
1/2
3
4
8
36
18
23
21
28
34
33
71 777 SHROUD
OPTION ONLY!
1
1/2
5
6
Advertisement
