Mounting The Motor - Powermatic 64A Instruction Manual

3. Attach the elevating and tilting handwheels with
lock knobs to the elevating and tilting screws on the
machine, as shown in Figure 5. Make sure the slot in
both handwheels engages with the roll pins in the el-
evating and tilting screws.

MOUNTING THE MOTOR

Tools required
10mm and 12mm wrenches
3mm and 4mm hex wrenches
WARNING: Make sure motor is
!
disconnected from power source while
assembling the saw.
1. Carefully set motor on its end with the pulley
sticking straight up, as shown in Figure 6.
2. Install two 5/16-18 x 1-3/4 carriage bolts through
the holes in the pulley cover seat. See Figure 7. Slip
a bushing over the bolt shafts and temporarily install
two 5/16 fiber washers, two 5/16 wing nuts, and two
E-rings as shown.
3. Lay the pulley cover seat on the motor as shown
in figure 8.
4. Install motor base plate with four 5/16-18 x 1 hex
head screws, four 5/16 flat washers, four 5/16 lock
washers, and four 5/16 nuts, with the screw heads on
the motor side, as shown in Figure 8. Slightly tighten
two of the nuts to temporarily secure components.
5. Assemble the motor base plate to the cast mo-
tor bracket as shown in Figure 9. Slip pin through and
secure with the hex head set screw.
IMPORTANT: Before mounting the motor assembly
to the saw, turn the trunnion handwheel so that the
saw blade is in the 90 degree vertical position (or the
saw's pointer is on the zero mark).
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
11