ParaBody 425104 Assembly Instructions Manual page 32

102
73
72
STEP 35
• To assemble the D-RING CABLE (102) follow the cable routing as shown and use the following steps:
• Screw one of the threaded ends of the D-RING CABLE (102) approximately 1" into the end of the SELECTOR SHAFT (73) of the HEAD
PLATE (72) as shown in FIGURE 35.
• Route the CABLE (102) up and over the two PULLEYS in the TOP BOOM (17) above the WEIGHT STACK. (Remove pulleys
for ease of installation.)
• Screw the other threaded end of the D-RING CABLE (102) approximately 1" into the end of the shaft on the D-RING (7) as shown in
FIGURE 35.
• SECURELY tighten two pulley connections from the previous step.
1/2
0
7
1/2 1/2
1 2
17
1/2 1/2
3 4
32
FIGURE 35
1/2
5
6