Setting The Knob Functions (Knob Mode); Switching Settings With The Number Pedals - Boss gt-8 Owner's Manual

Chapter 7 Other Features
Setting the Knob Functions
(Knob Mode)
This sets the way the values of settings are changed when the
control knobs are turned.
fig.07-201
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "Knob Mode" is displayed.
fig.07-210d
2. Rotate the PATCH/VALUE dial to set the Knob mode.
Value Explanation
Turning the knobs immediately changes
Immediate
the values.
Values begin to change only once the
Current Setting
knob position reaches the values set in the
patch.
3. Press [EXIT] to return to the Play screen.
74
1 2
3 1
]
Switching Settings with the
Number Pedals
The GT-8 includes a function that allows you to turn the
tuner on and off, switch preamp channels, and perform other
tasks by pressing the pedal with the same number as the
currently selected patch.
fig.07-059
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "SYS: NUM. Pdl SW" is displayed.
fig.07-060d
2. Rotate the PATCH/VALUE dial to select the function.
Value Explanation
Off
Not used.
Tuner
Switches the tuner on and off.
Solo
Switches the preamp SOLO on and off.
Switches between the preamp channels A
Amp Ch. Select
and B.
3. Press [EXIT] to return to the Play screen.
* When DELAY type (p. 30) is set to HOLD, the HOLD
recording/overdubbing function is operational, regardless of
the settings described above.
1 2
3 1
]