Using The Digital Outs; Adjusting The Output Of Digital Out; Checking The Effect Level With The Level Meter - Boss gt-8 Owner's Manual

Using the Digital Outs

Digital signals are output from the DIGITAL OUT connector
on the rear panel. You can connect this directly to the digital
in connector of a digital recorder or other device and record
with no degradation in sound quality.
fig.07-150

Adjusting the Output of DIGITAL OUT

You can adjust the level of the audio signals output from
DIGITAL OUT.
fig.07-152
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "SYS: Dgtl Out Lev" is displayed.
fig.07-153d
2. Rotate the PATCH/VALUE dial to adjust the output
level.
Valid Settings: 0%–200%
3. Press [EXIT] to return to the Play screen.
DIGITAL IN
1 2
3 1
]
Chapter 7 Other Features
Checking the Effect Level
with the Level Meter
You can meter the output level of each effect. This is handy
for checking the effects' output levels.
fig.07-131
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "METER" is displayed.
fig.07-140d
2. Rotate the PATCH/VALUE dial to select the effect
whose level you want to check.
* You can check the level of signals being input to the INPUT
jack by selecting "Input." Selecting "Output" allows you to
check the level of signals output from the GT-8.
* You may not be able to achieve the effects you envision if your
output levels are set too high. Adjust the output level of each of
your effects to the optimum value while checking the meter
and making sure the needle doesn't swing too far to the right.
3. Press [EXIT] to return to the Play screen.
For more information on the following system settings,
refer to p. 54–p. 56.
SYS: CTL Pdl Func
SYS: EXP SW Func
SYS: EXP Pdl Func
SYS: SubCTL1 Func
SYS: SubCTL2 Func
SYS: Sub EXP Func
1 2
3 1
]
75