Preliminary Operations - Gen Set MPM 6/230 S-L Use And Maintenance Manual

GB
06. INSTALLING AND STARTING THE MACHINE

06.1 PRELIMINARY OPERATIONS

BEFORE STARTING THE UNIT
(picture 1)
ENGINE OIL
The unit is delivered complete with
lubricating oil.
Check the oil level in the sump using the dipstick (1) located
on the right side of the engine (see Checking the oil level on
page 37); refill the correct level using the oil filler (2) or
(3), if necessary choose the oil viscosity according to the
;
ambient temperature (for other temperatures check the table
at page 38).
Wait at least five minutes, then check the oil level again.
It is important that the unit is sitting on level ground.
(picture 2)
FUEL CHECKING
Before starting the machine check the fuel level, and refuel
the tank if necessary.
To refuel the machine proceed as here under indicated:
• Remove the fuel cap (4).
• Proceed to fill up the fuel tank.
• Put the fuel cap back on.
• In case, clean up any spilled fuel immediately before starting
the machine.
pic.2
MPM 6/230 S-L
26
MI-M-00006200
pic.1
4
1
2
3