Magnet Mounting - H3C S5100-SI series Quick Start Manual

Quick Start
H3C S5100-SI/EI Series Ethernet Switches

3.4 Magnet Mounting

The S5100-8P-EI, S5100-16P-EI, S5100-8P-PWR-EI, and
S5100-16P-PWR-EI series Ethernet switches support magnet
mounting:
I. Introduction to magnetic accessories
Magnetic accessories consists of four permanent magnets and
four M3*6 countersunk head screws, as shown in Figure 3-18.
(1) Permanent magnet
Figure 3-18 Magnets and countersunk head screws
II. Installation procedure
Follow these steps to complete magnet mounting:
1) As shown in Figure 3-19, use a Phillips screwdriver to pass
the countersunk head screw through the round hole at the
central of the permanent magnet, fasten it to a blind nut in
(2)
3-20
Chapter 3 Installing the Switch
(1)
(2) M3*6 countersunk head screw