Initial Setup Page: Devices - Source fire Sourcefire 3D System Installation Manual

Setting Up a Sourcefire 3D System Appliance

Initial Setup Page: Devices

Initial Setup Page: Devices
Version 5.2
In most cases, you must provide the Defense Center's hostname or the IP
address along with the registration key, for example:
configure manager add DC.example.com my_reg_key
However, if the device and the Defense Center are separated by a NAT device,
enter a unique NAT ID along with the registration key, and specify
instead of the hostname, for example:
configure manager add DONTRESOLVE my_reg_key my_nat_id
To register a device to a Defense Center:
A : CLI Configuration
CCESS
1. Log in to the device as a user with Configuration CLI access level:
• If you are performing the initial setup from the console, you are already
logged in as the
• Otherwise, SSH to the device's management IP address or host name.
2. At the prompt, register the device to a Defense Center using the
command, which has the following syntax:
manager add
configure manager add {
IPv6_address
where:
•
{ hostname |
specifies either the fully qualified host name or IP address of the
Defense Center. If the Defense Center is not directly addressable, use
DONTRESOLVE.
• reg_key is the unique alphanumeric registration key required to register
a device to the Defense Center.
• nat_id is an optional alphanumeric string used during the registration
process between the Defense Center and the device. It is required if
the hostname is set to
3. Log out of the appliance.
The device is ready to be added to a Defense Center.
For all managed devices (except Series 3 devices that you configured using the
CLI; see Performing Initial Setup on a Series 3 Device Using the CLI
you must complete the setup process by logging into the device's web interface
and specifying initial configuration options on a setup page.
You must change the administrator password, specify network settings if you
have not already, and accept the EULA. You can also preregister the device to a
Defense Center and specify a detection mode; the detection mode and other
options you choose during registration determine the default interfaces, inline
Sourcefire 3D System Installation Guide
user, which has the required access level.
admin
hostname
reg_key
| DONTRESOLVE}
IPv4_address | IPv6_address
DONTRESOLVE.
Chapter 4
DONTRESOLVE
configure
| IPv4_address |
nat_id
[ ]
| DONTRESOLVE}
on page 91),
93