Foot Sw Type Setting - Roland CUBE 60XL BASS Owner's Manual

Using a Latch-type Foot Switch
The CUBE-60XL BASS/CUBE-120XL BASS also support latch-type foot
switches. If you're using a latch-type foot switch, make the following
settings.

FOOT SW TYPE setting

There are two types of foot switches.
Type Operation
Momentary type This type remains on (or off ) while depressed
(BOSS FS-5U, etc) and switches off (or on) when released.
Latch type This type switches on or off each time it is
(BOSS FS-5L, etc.) depressed.
* The BOSS FS-6 can operate as either a momentary or latch-type
pedal switch.
CUBE-60XL BASS
At the factory settings, the momentary type is selected. You can
change this setting as follows.
• To specify the latch type
Turn on the power while holding down the [TAP/STOP] switch.
• To specify the momentary type
Turn on the power while holding down the [REC/PLAY/DUB] switch.
* The setting you specify is remembered even while the power is
turned off.
CUBE-120XL BASS
Set the [FOOT SW TYPE] switch on the rear panel
to FS-5L (LATCH).
Foot Switch Settings
BOSS FS-5L
(RING) (TIP)
REVERB EFX
COMP/DRIVE SOLO
BOSS FS-6
REVERB EFX
COMP/DRIVE SOLO
Polarity switch
Set the switches as shown as bellow.
B A
BOSS FS-5L+FS-5U
(RING) (TIP)
TAP/STOP DELAY/
REC/PLAY/DUB
BOSS FS-6
TAP/STOP DELAY/
REC/PLAY/DUB
* Even if FOOT SW TYPE is set to FS-5L (LATCH), you must always use
a momentary-type foot switch for TAP/STOP. This function will not
work correctly with a latch-type foot switch.
Important Notes When Using a Latch-type Footswitch Pedal
The on/off state of the footswitch pedal takes precedence over the
control panel for switching COMP/DRIVE, EFX, DELAY, or REVERB on
and off.
However, the on or off states of COMP/DRIVE, EFX, DELAY, or REVERB
stored in memory using the SOLO function take precedence when
saved SOLO-function panel settings are called up. Such cases may
result in conflicting indicator displays on the control panel and the
footswitch pedal, but this is not a malfunction.
Convenient Applications
You can use either of the following settings to control operation when
the panel settings for COMP/DRIVE, EFX, DELAY, and REVERB are called
up using the SOLO function.
Foot switch priority mode
Make the on/off state of the footswitch pedal always take priority.
To make the setting:
Hold down the [SHAPE] switch and switch on the power.
Memory priority mode (factory setting)
Make the on/off state saved using the SOLO function take priority.
To make the setting:
Hold down the [TUNER] switch and switch on the power.
* The changed setting remains in memory after the power is switched
off.
Polarity switch
Set the switches as shown as bellow.
B A
11