Installing The Inner Dome Liner; Figure 1-9 Camera Assembly; Figure 1-10 Slide Inner Dome Liner Into The Lower Dome - Honeywell JOSI-DBC012-N11 Installation Manual

Installing the Camera
Gimbal ring
Gimbal chassis

Installing the Inner Dome Liner

1
22
Figure 1-9 Camera Assembly
Note After installing the camera assembly, you need to adjust and focus the
camera before installing the lower dome to complete the installation process.
To adjust and focus the camera, see
Note The lower dome might affect the focus. After installing the lower dome, you
should check the focus. If the focus needs adjustment, uninstall the lower
dome, make the adjustments, reinstall the lower dome, and then recheck the
focus.
1. Slide the inner dome liner on an angle into the lower dome so that one side fits
snugly into place.
Figure 1-10 Slide Inner Dome Liner into the Lower Dome
Inner Dome Liner
In-Ceiling
2. Push down on the other side until it snaps into place.
Bracket tabs (x2)
Adjusting the Camera
Inner Dome Liner
1
2
Lower Dome
Loosen thumb
nuts (x3)
on page 25.
2
Pendant