Table of Contents
Advertisement
Document 800-01605 Rev A
04/08
Figure 1-5
Spacing Wing Tabs
b.
Position the wing tabs flat against the housing. Insert the housing through the
hole in the ceiling (some jostling is required). Using a Phillips screwdriver, turn
the two screws in the housing clockwise to rotate the tabs out and tighten the
tabs against the ceiling. The recommended maximum torque is 1–1.25 N-m
(Newton meters) or 0.74–0.92 lbf-ft (pound-force-foot) or 8.85–11.06 lbf-in
(pound-force-inch).
6.
Refer to
Connecting the Cables
wiring to the interface board in the housing.
7.
See
Installing the Camera Assembly
camera assembly and
installing the lower dome.
Indoor Pendant Housing Installation
WARNING!
Installation must be performed by qualified technical
personnel and must be in accordance with all national and
local mechanical and electrical codes.
Perform the following steps to install an ACUIX™pendant housing on a Honeywell Video
Systems indoor wall dome mount or ceiling dome mount. See
1.
Select the location of the housing. Each ACUIX™ Fixed requires either a 17 to 28
VAC or an 11 to 16 VDC power source measured at the housing. Each ACUIX™
Fixed has a power consumption of 3.5W for the color cameras or 4.5W for the WDR
cameras. Ensure a 24 VAC/12 VDC @ 0.2A power source is available. See
Appendix B, Cable Guidelines
dome.
2.
Install the mount using the instructions provided with your specific mount.
3.
Run the field wiring (control data, video, power, and alarm) through the mount. The
wiring must extend at least one foot (0.3 m) past the pipe for wiring purposes. See
Cable Guidelines
on page
4.
Locate the pendant housing.
ACUIX
on page
20
for information on connecting the field
on page
21
for information on installing the
Installing the Lower Dome
on page
on
page 35
for maximum wiring distances to the
35
for detailed wiring information.
TM
Fixed Dome User Guide
23
for information on
Figure
1-6.
19
Advertisement
Table of Contents
