Connecting Cables Through The Housing Base - Honeywell HD4U User Manual

Connecting Cables Through the Housing Base

For installations that require pulling cables through the grommet located in the bottom of the
base:
Use a sharp knife to cut an ! opening in the base gasket (see
1.
opening should be only big enough to feed the cable assembly through.
2. Pull the cabling through the opening.
3. Apply appropriate sealant around the opening to prevent moisture from entering the
housing.
Figure 1
!
Base gasket opening
Document 800-00031 Rev A
04/08
Cable Connection Through Grommet
Figure 1). Be careful. The
9