Anslut 417-078 Operating Instructions Manual page 25

1. Grip both sides firmly and pull the
container straight out.
NOTE:
• Do not touch any parts inside the dehumidifier when removing the water container, this could damage the dehumidifier.
• Push the water container carefully into the dehumidifier, otherwise the dehumidifier can be damaged.
Continuous drainage
The water can be drained automatically to a drain via a hose with a
diameter of 16.5/13.5 mm (sold separately).
1. Remove the drain plug on the back of the dehumidifier and
put it in a safe place.
2. Connect the hose. Check that the connection is tight.
3. Put the end of the hose in a suitable drain. The drain must be
lower than the outlet on the dehumidifier.
4. The hose must go down towards the drain. Avoid bending or
running the hose over obstacles.
NOTE: Remove the hose and insert the rubber plug when the hose is
not in use.
NOTE:
• Do not bend the drain hose.
Automatic switching off
The float switch switches off the dehumidifier when the water container is full, or not properly inserted, and when the water container is taken
out. The dehumidifier switches off automatically when the set target humidity is reached.
Start delay 3 minutes
When the dehumidifier has been stopped it will not start for 3 minutes. This is a safety function, and is completely normal. The dehumidifier
starts automatically after 3 minutes.
Automatic defrosting
If frost forms on the evaporator coils the compressor will switch off, and the fan will run until the frost has melted.
Automatic restart
When the power supply is reset after a power failure the dehumidifier restarts with the previously set function.
2. Lift up the water container.
• Do not bend the drain hose.
3. Empty out the water.
EN
25