Time Code Menu; User Menu - Panasonic AJ-D650 Operating Instructions Manual

Setup (setting) menus

USER menu

<TIME CODE>
No.
500
501
502
503
504
505
506
The underline on the setting item denotes the initial setting.
Item Setting
Superimposed No. Superimposed
display
display
0000
VITC
POS-1 0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
VITC 0000
POS-2 0001
0002
0003
0004
0005
0006
0007
0008
0009
0010
BLANK
VITC 0000
BLANK 0001 THRU
TC&UB
TCG 0000
REGEN 0001
0002
REGEN 0000
MODE 0001
EXT TC
0000
SEL 0001
BINARY 0000
GP 0001
0002
0003
0004
0005
0006
0007
– 3 3 –
Description
10L
This sets the position where the VITC signal is to be inserted.
11L
(The same line as for VITC POS-2 in 501 cannot be
selected.)
12L
13L
14L
15L
16L
17L
18L
19L
20L
10L
This sets the position where the VITC signal is to be inserted.
11L
(The same line as for VITC POS-1 in 500 cannot be
selected.)
12L
13L
14L
15L
16L
17L
18L
19L
20L
This selects whether to output the VITC data to the positions
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
This selects the signal to be regenerated when the time code
TC generator (TCG) in the REGEN mode.
0: Both the time code and user bit are regenerated.
UB
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
OFF This selects whether values used in the internal time code
ON generator are preset from the front panel or remote controller
or synchronized with time code values read from the tape.
0: Values are preset from the front panel or remote
controller. (PRESET)
1: Values are synchronized with time code values read from
the tape. (REGEN)
<Note>
When "1" is selected, values selected at set up menu No.503
(TCG REGEN) are regenerated.
This selects the time code to be used when an external time
LTC
code is to be used.
VITC
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
000
This sets the usage status of the user bit of the time code
generated by the TCG.
001
0: NOT SPECIFIED (character set not specified)
010
1: ISO CHARACTER (8 bits character set based on lSO646,
011
lSO2022)
100
2: UNASSIGNED 1 (undefined)
101
3: UNASSIGNED 2 (undefined)
110
4: UNASSIGNED 3 (undefined)
111
5 : PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)