How To Release The Menu Protect Mode; How To Display The Diag Menu - Panasonic AJ-D250P Operating Instructions Manual

Setup (Initial Settings)
5
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position. The unit is now
set to the menu protect mode.
When the LOCAL/MENU/REMOTE switch is set
to the MENU position, "MENU PROTECTED"
appears on the video monitor screen instead of
the menu setting mode being established.
<Note>
If, while the menu protect menu is set, the
LOCAL/MENU/REMOTE switch is set to the
menu position while the front panel's COUNTER
button is held down, the menu setting mode will
be established, and regular menu settings can be
performed.
2
Perform steps through
the settings using the on-screen menus."
(See page 23)
How to release the menu
protect mode
1
Set the LOCAL/MENU/REMOTE switch to the
MENU position while holding down the front
panel's COUNTER button.
The unit is now set to the menu setting mode,
and the menu screen appears on the video
monitor.
2
2
Perform steps and
menu protect mode" described above.
The screen to confirm whether menu protect is to
be initiated or canceled now appears on the
video monitor.
MENU PROTECT OK?
NO
YES
3
Press the MENU-UP button or MENU-DOWN
button to move the cursor to the NO position,
and press the SET button.
The menu protect mode is now released.
7
in "How to perform
3
of "How to initiate the

How to display the DIAG menu

This unit incorporates a function for displaying the
HOURS METER and software program version on the
video monitor.
1
Set the LOCAL/MENU/REMOTE switch to the
MENU position while holding down the EJECT
button.
The unit is now set to the DIAG display mode,
and the HOURS METER appears on the video
monitor.
DIAG–MENU
H0 OPERATION
H1 DRUM RUN
H2 TAPE RUN
H3 THREADING
2
With the HOURS METER displayed, press the
MENU-UP button or MENU-DOWN button
while holding down the MODE button.
The software program version is displayed on the
video monitor.
The front microcomputer version appears on the
front panel's counter display.
DIAG–MENU
<NTSC>
IF
AV-SYSCON
SBC
CYLINDER
REEL
END
When the MENU-UP button or MENU-DOWN
button is pressed again while holding down the
MODE button, the HOURS METER display is
restored.
3
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
The normal mode is now restored.
26
HOURS METER
00000H
00000H
00000H
00000T
VERSION
1. - - .
1. - - .
1. - - .
1. - - .
1. - - .