Connect To Power - Uniden DC4 Owner's Manual

cup on the windshield and press down on the suction clamp to
secure the bracket.
5. Two knobs adjust the camera's position. Loosen the top knob on
the side of the bracket to adjust the camera's vertical position.
Loosen the bottom knob to adjust the camera's horizontal
position.
6. To remove the bracket from the windshield, release the suction
cup, hold the camera securely, and lift the suction clamp.

CONNECT TO POWER

1. Connect the car adapter's miniUSB plug to the DC4's miniUSB
port.
2. Connect the cigarette lighter adapter plug to the vehicle's
cigarette lighter port.
3. The device turns on. Red lights indicate the device is recording;
green lights indicate the device is in stand-by mode.
In certain models of cars, the cigarette lighter keeps providing power
even when the engine is off. Be sure to remove the car charger
or disconnect the device when leaving the vehicle to prevent
draining the vehicle battery. Check your vehicle's owner's manual to
determine if this applies to your vehicle.
Bracket Suction
Clamp
Horizontal
Bracket
Adjustment
Connector
Knob
Vertical
Adjustment
Knob
5