Philips HR 8374 Service Manual

Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
- Maximum air displacement
- Maximum vacuum water column
- Power consumptio (IEC) 225V
- Dust storage capacity
- Cord length (depends on version)
- Filter system
- Dimensions cleaner
- Weight accessoiries
- Noise
- Colour
- Electronic controled motor rpm
- Cordwinder build-in with fl at cord
- Dustbag-full indicator in dustcover
OPTIONAL
Combi exhaust air fi lter
Sydney cotton dustbag
Sydney 3M dustbag
Sydney paper dustbags
Turbo brush con.
Polishing nozzle con.
This product meets the requirements regard-
ing interference suppression on radio and TV.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
Published by Philips Domestic Appliances and Personal Care
4322 277 00362
02/08
City Line Sydney
: 34 l/sec
: 280 cm
: 1400 W
: 2 litres
: 6 m
: 6 fi lters
: 37 x 28 x 23 cm
: 4.3 kg
: 80 dB
: Light blue
(4322 004 22240)
HR 6997 (8836 997 01010)
HR 6999 (8836 999 90010)
HR 6999 (8836 999 01010)
HR 6988 (4822 479 20196)
HR 8040 (4322 004 22330)
Printed in the Netherlands

Vacuum cleaner

SERVICE INFORMATION
- To open the appliance, fi rst remove the screws A,B,C,D.
- To reach the motor remove the screws E.
- To disassemble the cordwider use Torx screw driver no T10,
which is one of set consisting of T20, T15, T10, T9, T8, T7 and
T6 = 4822 395 50145.
- Give attention that the contact fi ngers (item 45) are placed on the
cord-winder shaft in such a way that the pressure point of the
cordwinder knob to the cord winderlever (item 40) is vertical.
- The spare parts have been standardized as much as possible.
- Component confi guration on exploded view may differ in case
of specifi c versions, however, the actual components are distin-
guished by means of code numbers.
- Item 1 Cotton dustbag is used in those countries where paper
dustbags are not available
- Item 41 Cord-winder spring unit is provided with a long spring,
both long and short cords can be used in combination with this
spring.
- Cordwinder spring has to be tensioned till maximum minus
approx. 1,5 revolution.
- First remove the two screws
B of (item 15) hinge turn +
window. Remove (item 15) hinge
turn + window from (item 3)
upper housing by means of a
fl at instrument (e.g. screw driver)
as shown (to prevent demage).
The hinge turn + window has
snaps which fi ts into the upper
housing. Vario / knob turn
(item 10 ) can now be separated
as shown in next drawing.
- Place the knob turn in line with
the adjuster item 10A. Hook
(item 15) hinge turn + window
into the (item 3) upper housing.
Use the 2 screws (item B) to
fasten item 15 to item 3. Place
the cover of vario / knob turn
(item 10) in the correct way;
only on one way possible.
© Copyright reserved
HR 8374
1
B
B
2
4
B
3
B
2
1
Subject to modification