Storage; Troubleshooting - Hoover fh50800 Owner's Manual

storaGe

• Empty and rinse out
clean and dirty water
tanks and leave to air
dry before replacing.
• You can remove the
handle (3.13) and tool
caddy for convenient
storage (3.14).
CAUTION
!
Do not store carpet cleaner with solution in tanks.
lubriCation
The motor is equipped with bearings which contain sufficient lubrication for the life of the motor.
The addition of lubricant could cause damage.
do not add lubricant to motor bearings.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce the risk of personal injury - unplug cleaner before cleaning or servicing.
probleM possible Cause
Cleaner won't 1. No voltage in wall.
run
2. Blown fuse or tripped breaker.
3. Unit cuts out during use.
4. Thermal protector has tripped.
Cleaner won't 1. Dirty Water Tank Door not
installed.
pick-up or low
suction
2. Dirty Water Tank is not installed
correctly.
3. Dirty Water Tank is full.
4. Dirty water passage clogged.
5. Foam filter is dirty.
6. Blockage in hose or brushroll.
Water escap- 1. Dirty Water Tank is full.
ing from
2. Dirty Water tank is not installed
Cleaner
correctly.
3. Clean Water Solution Tank not
installed properly.
3.13
!

4. troublesHootinG

WARNING
!
3.14
!
possible solution
1. Check fuse or breaker in home.
2. Check fuse or breaker in home. Replace
fuse/reset breaker in home.
3. Take to service center. To find nearest
location, visit our website at www.hoover.com
or call 1-800-944-9200.
4. Disconnect the unit from the wall socket,
allow to cool for 30 minutes, clean the filter
and empty the dirtywater tank and check
hose, brushroll for blockages.
1. Insert Dirty Water Tank Door - Pg. 9.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 10.
3. Empty Dirty Water Tank - Pg. 10.
4. Clean Dirty Water Tank - Pg. 10.
5. Clean filter. Review Emptying & Cleaning the
Dirty Water Tank - Pg. 10.
6. Check for blockage and remove - Pg. 11.
1. Empty Dirty Water Tank - Pg. 10.
2. Review Placing Dirty Water Tank in base of
cleaner - Pg. 11.
3. Review Clean Water Solution Tank
Installation - Pg. 8.
12