Cleaning Filter; Belt - Hoover fh50800 Owner's Manual

CleaninG filter

3.5 Rotate dirty water tank handle down,
grasp filter tab and remove.
3.6 Rinse under water to remove debris
o o
(below 140 F/60 C). Allow to dry completely
before replacing or storing away your
machine.

belt:

How to remove and replace
CAUTION
!
To reduce the risk of injury from moving parts -
unplug before servicing.
DO NOT OPEN MOTOR COVER.
How to remove
Before servicing, remove Dirty Water tank and
Solution tank to avoid spillage
3.6 Turn cleaner on its side to expose nozzle base.
To remove belt cover, use Phillips screwdriver to
remove the two screws. Arrows show location of
screws.
3.7 Grasp belt cover near brushroll and lift out.
3.8 Grasp brushroll with one hand, using other hand
to keep tension on belt when removing. Lift up when
pulling out.
How to replace
3.9 Remove belt. Dispose of old belt.
3.10 Place new belt on motor shaft (A), then stretch
belt over brushroll pully.
3.11 Replace belt cover (C) and secure by replacing
the two screws (D).
IMPORTANT
Rotate brushroll manually to make sure belt is
not twisted or pinched.
belt: what to buy
For Belt replacement, please call 1-800-944-
9200 or visit our website at www.hoover.com to
locate a dealer nearest you. Belt part #440002313.
reMovinG bloCkaGes froM brusHroll
CAUTION
!
To reduce the risk of injury from moving parts -
unplug before servicing.
3.5
3.6
!
3.8
3.10
A
3.12 Remove any debris
!
and/or hair from brushroll.
11
3.5
3.7
3.9
3.11
b
3.12
C
d