!
Service
Information
Philips Domestic Appliances and Personal Care
Service Manual
PRODUCT INFORMATION
- Maximum air displacement
- Maximum vacuum water column
- Power consumption (IEC)
- Dust storage capacity
- Cord length
- Filter system
- Dimensions cleaner
- Weight cleaner
- Colour cleaner
- Noise
OPTIONAL
Exhaust air fi lter
Active carbon fi lter
Active carbon fi lter replacem. set
S-class fi lter
S-class fi lter replacement set
Sydney cotton dustbag
Sydney closable pap. dustbag
Sydney 3-M dustbag
This product meets the requirements regard-
ing interference suppression on radio and TV.
Published by Philips Domestic Appliances and Personal Care
4322 277 00259
00/03
PCS 101 398
Mobilo
: 37 l/sec.
: 310 cm
: 1400 W
: 3 litres
: 6.3 metres
: Paper dustbag
: Motor inlet fi lter
: Exhaust air fi lter
: 44.5 x 29.5 x 25 cm
: 5.5 kg
: Green
: 77 dB
HR 6932 (8836 932 01210)
HR 6949 (8836 949 01010)
HR 6968 (items 12 + 13)
HR 6992 (8836 992 01010)
HR 6994 (items 19 + 20)
HR 6997 (8836 997 01010)
HR 6999 (8836 999 01010)
HR 6999 (8836 999 90010)
Printed in the Netherlands
Vacuum cleaner
SERVICE INFORMATION
- To open the appliance, fi rst
remove the 2 screws of the
control panel (item 11) then
with a big screw driver dis-
connect the 2 snap locks
of panel and lower housing
(see drawing).
- Component confi guration on exploded view may differ in case
of specifi c versions. However, the actual components are distin-
guished bij means of code numbers.
- The spare parts have been standardized as much as possible.
- Item 6, cotton dustbag, is used in those countries where paper
dustbags are not available.
- Item 21 is provided with a long cord-winder spring; both long and
short cords can be used in combination with this spring.
- Cordwinder spring has to be tensioned till maximum minus approx.
1,5 revolution.
- Depending on the original length of the cord, the spare cord must
be shortened.
- To (dis)assemble the appliance use TORX screw driver no T15
= 4822 395 10329, which is one of a set consisting of T20, T15,
TI0, T9, T8, T7 and T6 = 4822 395 50145.
- Adjusting the PCB on the motor to 220V, 60Hz.
1. Make sure that the potentiometer (item 36) is set at min.
position.
2. Adjust the potentiometer on the PCB item 45, on the motor to
220V/60Hz to allow the motor to run smoothly.
Please note: the standard setting of the spare PCB is
230V/50Hz.
There are open-circuit voltages on all wires.
After the product has been repaired, it should
function properly and has to meet the safety
requirements as offi cially laid down at this
moment.
© Copyright reserved
HR 8569
Subject to modification