Oki LD670 User Manual page 147

№ Item
5 Layout Er Process
6 Layout Er Recovery
7 Feed at Power On
8 Mark Feed with Cut
9 Sensor Auto Adjust
10 Return to Up
11 Return to Top Menu
Explanation
Specifies the action to be taken if a
paper layout error occurs.
- Specify whether to clear the paper
layout error information stored in
memory.
- To continue using the same paper, do
not clear the paper layout information.
- To use a different type of paper, clear
the paper layout information.
Specifies the condition for recovery
from a paper layout error.
- Command transmission may be
impossible, such as because the receive
buffer is in the full state, if a paper
layout error occurs. In this case, use
Command/Cover Close instead of
Command.
Specifies whether to feed paper to the
start position at power-on.
- If Disable is specified and the head is
not positioned at the start position at
power-on, a print misalignment or
paper layout error may result.
Specifies whether to cut paper after
feeding paper to the start position.
- If Enable is specified, the printer cuts
the paper that has been advanced to
the start position as triggered by a
power-on, a reset, the closing of the
cover, or the pressing of the FEED
switch. The printer does not cut the
paper that is fed to the start position
by a command.
Specifies whether to automatically
adjust the label and black mark
sensors when automatic setting of the
paper layout is enabled.
Returns to the selection mode for the
setup group items.
Returns to the setup mode menu.
145
Detailed setup item
Layout Continue
Layout Clear
Command/CoverClose
Command
Enable
Disable
Enable
Disable
Enable
Disable
-
-