Specifications; Operation - Ryobi CRO-180 User Manual

GB
FR DE ES IT
SPECIFIC SAFETY INSTRUCTIONS FOR
SANDERS
Always wear safety goggles and a dust mask
when sanding, especially sanding over-head.
The machine is not suitable for wet sanding.
Do not use sanding paper larger than needed.
Extra paper extending beyound the sanding pad can
also cause serious lacerations.

SPECIFICATIONS

Motor
Orbit Diameter
No Load Speed
Pad size
MODEL BATTERY PACK
(not included)
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
CRO-180 BPL-1820
BPL-1815
BPP-1815
BPP-1815M
BPP-1817
BPP-1817M
DESCRIPTIONS
1. Hook-and-loop sanding disc
2. Switch
3. On ( I )
4. Off ( O )
5. Battery pack (Not Included)
6. Latches
7. Depress latches to release battery pack
8. Backing pad

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second issufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with
CRO-180M_EU_Manual.indd Sec1:1 CRO-180M_EU_Manual.indd Sec1:1
NL PT DK SE FI NO
English
18V
1.6 mm.
-1
10,000 min
125 mm
CHARGER
(not included)
BCL-1800
BCS-618
BC-1815S
BC-1800
RU PL CZ HU RO LV
side shields when operating products. Failure to
do so could result in objects being thrown into
your eyes, resulting inpossible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purposes listed below:
Sanding on wood surfaces
Removing rust from and sanding steel surfaces
TO INSTALL BATTERY PACK (NOT INCLUDED) Fig.2
Place the battery pack on the tool.
Make sure the latches on each side of the battery
pack snap into place and the battery pack is secured
on the tool before beginning operation.
TO REMOVE BATTERY PACK (NOT INCLUDED) Fig.2
Depress the latches on the side of battery pack.
Remove the battery pack from the tool.
BATTERY PROTECTION FEATURES
Ryobi 18 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life. Under some operating conditions, these
built-in features may cause the battery and the tool it is
powering to act differently from nickel-cadmium batteries.
During some applications, the battery electronics may
signal the battery to shut down, and cause the tool to
stop running. To reset the battery and tool, release the
trigger and resume normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and
tool, the battery pack is depleted. If depleted, the battery
pack will begin charging when placed on the lithium-ion
charger.
SANDING DISC SELECTION
Selecting the correct size grit and type sanding disc is
an extremely important step in achieving a high-quality
sanded finish. Aluminum oxide, silicon carbide and
other synthetic abrasives are best for power sanding.
Natural abrasives, such as flint and garnet are too soft for
economical use in power sanding.
1
LT EE HR SI SK GR
4/26/09 10:41:11 AM 4/26/09 10:41:11 AM
TR