7. Connect the AC power cord (country-specific) to the rear of the unit.
8. Plug the opposite end of the power cord into an electrical outlet to power the switch.
N O T E
Tabletop Deployment
To deploy an Alcatel-Lucent 4306G OmniAccess Switch on a flat surface, such as a tabletop:
1. Insert the four rubber mounting feet to the bottom of the unit.
2. Attach side bezels by snapping them into place.
3. Place the unit on a hard flat surface.
Initial Setup and Network Connectivity
Once the physical installation is complete, run the initial setup on the switch to configure the IP address and other basic
system information. For complete details and instructions, refer to the AOS-W Quick Start Guide.
Removal
To remove an Alcatel-Lucent 4306G OmniAccess Switch from a 19-inch (48.26 cm) rack system:
1. Disconnect the power to the switch by unplugging the power cord from the electrical outlet.
2. Loosen the four rack mount screws securing the switch to your organizations rack system.
3. Remove the switch from the rack system.
Alcatel-Lucent 4306G OmniAccess Switch | Installation Guide
Alcatel-Lucent 4306G OmniAccess Switch controller does not have a switch for turning power to the
unit on or off. Power to the unit is controlled by connecting or disconnecting the plug on the power
cord to or from an electrical outlet.
Installation | 15