Operation - Panasonic AW-HB505 Operating Instructions Manual

OPERATION

1. Power
Set the power switches on the pan/tilt head AC adapter
and the multiport hub AC adapter to the ON position,
then set Power control Switch on the multi control panel
to the ON position.
2. Pan/tilt Limiter Setting for Pan/tilt Head
If there are obstacles around the pan/tilt heads, set the
limiters to limit the operating range (pan left and right
ends, tilt up and down ends) of the pan/tilt head.
Note: The switches on the pan/tilt head have been pre-
set before shipment from the factory on the
assumption that the pan/tilt head would be sus-
pended from the ceiling.
mounted on a board, for example, be sure to shift
the mounting direction switches on the pan/tilt
head. Unless this is done, pan/tilt directions will be
reversed and pan/head operation limiter data can-
not be properly stored in the memory. For details
on shifting these switches, refer to INSTALLATION
OF PAN/TILT HEAD at page 8 or the Operating
Instructions for Pan/tilt Head.
If the pan/tilt head is
-15-
Up tilting limiter
Left panning
limiter
1 2
6 7
M E M O RY
Preset
Down titing
memory
limitor
switch
q Select a pan/tilt head with the CONTROL switch on the
multi hybrid control panel.
w Left Panning Limiter
Turn the pan/tilt head to the desired left panning limit
with PAN/TILT Lever of the multi hybrid control panel,
keep MEMORY Switch depressed, and simultaneously
press buttons [1] and [6] of PRESET Switch for 5 sec-
onds or more. When the desired limit has been set,
button [5] of PRESET Switch lights.
To reset the limit, keep the MEMORY switch
depressed, and simultaneously press buttons [1] and
[6] of PRESET Switch again for 5 seconds or more.
When the set limit is reset, button [10] of PRESET
Switch lights.
Preset position selection switch
Lights on
P R E S E T
completion
3 4 5
of setting
Lights on
8 9 1 0
completion
of resetting
Right panning
limiter