Panasonic AW-HB505 Operating Instructions Manual page 22

• Total Pedestal Adjustment
Total pedestal adjustment is made to adjust the
pedestals of two or more cameras. Using an oscillo-
scope or a waveform monitor, adjust the pedestals to 5
IRE (0.035 V) or 7.5 IRE (0.050 V) with T.PED Control of
the multi hybrid control panel.
T. PED Control
T. P E D C A B L E C O M P
Y C
3) Set the switches for gain, shutter, etc. as appropriate
to the conditions of using the camera.
4) Set the camera control switch on the multi hybrid con-
trol panel to the OFF position.
5) Repeat Steps 1 to 4 to finish cable compensation, G/L
adjustment, total pedestal adjustment, and switch set-
ting for all the cameras.
5 IRE (0.035V) or
7.5 IRE (0.050V)
-20-
4. White Balance and Black Balance
Setting
1) Select a camera with the CONTROL switch on the multi
hybrid control panel.
2) Select a camera with the CONTROL switch on the multi
hybrid control panel.
• White balance adjustment is necessary when using the
camera for the first time, or if the camera has not been
used for a long period of time.
• Once the white balance is adjusted, no readjustment is
necessary if the camera is used under the same condi-
tions.
• Automatic White Balance Control (AWC)
The color temperature conditions for two channels A
and B can be stored in the memory in advance. Once
the white balance is adjusted, all that is needed is to
select either AUTO/ATW A Switch or AUTO/ATW B
Switch of the multi hybrid control panel. if the camera is
used under the same conditions. No readjustment is
necessary. If the white balance is readjusted, the exist-
ing white balance data is replaced with new data.
q Press either AUTO/ATW A Switch or AUTO/ATW B
switch of the multi hybrid control panel.