Accessories; Basic Operation - Panasonic GA-MLD16TPoE+ Installation Manual

1.3 Accessories

Please be sure to confirm the content.
Please contact our distributor if any of the contents are insufficient.
 Installation Guide (this document)
 Rubber foot
 Rack mount bracket (for 19-inch rack)
Screw (for 19-inch rack)
Screw (for fixing the mount brackets to the Ethernet Switch)
 Power cord
[Power Cord]
The following power cord is supplied as per the intended nation of delivery.
Product Number
PN261693D-NZ
[Optional accessories]
 PN54022-XX 1000BASE-SX SFP Module(i)
 PN54024-XX 1000BASE-LX SFP Module(i)
The XXs are identical to the intended nation of delivery codes.

1.4 Basic operation

This Product does not have a power ON/OFF switch. Connect the supplied power
cord to this Ethernet Switch and connect the other end into an electric outlet.
This Ethernet Switch operates at AC 100 - 240 V (50/60 Hz).
When power is supplied, all the LEDs are turned ON.
Then, POWER LED (Power) lights in green, STATUS/ECO LED (Status/ECO mode)
lights in orange, and self-diagnosis of hardware is executed.
On completion of self-diagnosis, POWER LED (Power), STATUS/ECO LED
(Status/ECO mode), TEMP LED (Temperature sensor) and FAN LED (Fan sensor) light
in green, and the Ethernet Switch starts operation as a Ethernet Switch.
As this Ethernet Switch succeeds in communicating with a terminal connected to
each port, LED of the port lights up.
When the terminal is not operating normally, for example when power is not
supplied to the terminal, LED is not lighted.
* For the configuration and management method, please see the PDF version
Operating Instructions on Panasonic's website.
Locale Power Cord Rating
Australia 250 VAC 10 A
New Zealand
FUSE Rated Current
- AS/NZS 3112
Quantity
1 (*)
4
2
4
8
1
Plug Type
11