Geometry - Whyte 801 Service Manual

WHYTE Service Manual
6.0: TORQUE SETTINGS
Whyte 19 Dropout System
M6 x 14mm Pivot Screw
M6 x 16mm Clamping Screws
Torque explained: If no suitable Torque Wrench is available a Torque of 5 lbf.ft can be obtained by ap-
plying a force of 5lb, with a Spring Balance, to the end of a spanner, 1 Foot in length.
IMPORTANT: For all other torque settings, refer to the specific manufacturers information
bundled with this manual, or alternatively, refer to the specific manufacturers website for
further information.
7.0: NOTES
Page 16
Nm lbs.ft
13 - 15 9.5 - 11
13 - 15 9.5 - 11
2010 Edition 1
WHYTE Service Manual

2.0: GEOMETRY

Fig.1:
Geometry
2.1: WHYTE 19 TRAIL, TI & STEEL
Frame Size X Small
Head Angle A 67.7 - 68.2°
Seat Angle B 72.2 - 72.7°
C 565.1mm
Top Tube
D
BB Height* 319.7mm - 325.7mm
Stand Over E 775mm
Wheel Base F 1065.3mm - 1082.5mm
Chain Stay G 415mm - 435mm
Seat Post H 30.9mm
Note:
Geometry shown here is 'Showroom' i.e. without rider aboard the bicycle. 'With Sag' geometry is with rider after correct
sag is set at the front. Please refer to suspension set up for information on how to achieve the correct sag of the fork.
* BB height with Ø677mm tyres fitted (2.25" / 54-559)
2010 Edition 1
Medium Large
67.7 - 68.2° 67.7 - 68.2°
72.2 - 72.7° 72.2 - 72.7°
584.5mm 609.6mm
319.7mm - 325.7mm 319.7mm - 325.7mm
797mm 823mm
1085.2mm - 1102.4mm 1111.1mm - 1128.3mm
415mm - 435mm 415mm - 435mm
30.9mm 30.9mm
Page 5