Yamaha RX-V461 Owner's Manual page 29

If an error screen appears
Press G k / n / l / h to select "RETRY" or
"EXIT" and then press G ENTER.
The following display is an example where "E-5:USER
CANCEL" appears in the OSD.
AUTO:ERROR
. E-5:USER CANCEL
Don't operate
any function
>
RETRY
[ ]/[ ]:Select
[ENTER]:Return
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
EXIT
Optimizing the speaker setting for your listening room
If "WARNING" appears
When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" appears in the
"RESULT:EXIT" display. Check the warning messages to
correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
1
Make sure the pointer is pointing at
"WARNING" and then press G ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO:RESULT
. WARNING(1)
RESULT
SP :
DIST:
LVL :
>
SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
2
Press Gl / h repeatedly to toggle between
the warning displays.
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
--
CENTER
--
[p]/[[]:Select
[ENTER]:Return
y
• For details about each warning message, see the "AUTO
SETUP" section in "Troubleshooting" on page 64.
• When the corresponding warning message is not
applicable to a speaker, "– –" is displayed instead.
Press G ENTER to return to the top
3
"RESULT:EXIT" display.
3/2/0.1
3.2/3.5m
-2/+2dB
CANCEL
FR
--
27
En