HP 5900 Series Configuration Manual page 53

Hide thumbs Also See for 5900 Series:

Command reference manual (364 pages)

Configuration manual (190 pages)

Compliance and safety manual (59 pages)

Table Of Contents

Table of Contents

[Sysname-irf-port4/1] port group interface ten-gigabitethernet 4/0/46

[Sysname-irf-port4/1] quit

# Bind Ten-GigabitEthernet 4/0/47 and Ten-GigabitEthernet 4/0/48 to IRF-port 4/2.

[Sysname] irf-port 4/2

[Sysname-irf-port4/2] port group interface ten-gigabitethernet 4/0/47

[Sysname-irf-port4/2] port group interface ten-gigabitethernet 4/0/48

[Sysname-irf-port4/2] quit

# Bring up the SFP+ ports and save the configuration.

[Sysname] interface range name irf

[Sysname-if-range-irf] undo shutdown

[Sysname-if-range-irf] quit

[Sysname] save

# Activate the IRF port configuration.

[Sysname] irf-port-configuration active

Device D reboots to join the IRF fabric. A four-chassis IRF fabric is formed.

Configure ND MAD on the IRF fabric:

# Enable the spanning tree feature globally on the IRF fabric to prevent loops.

<Sysname> system-view

[Sysname] stp global enable

# Configure the IRF fabric to change its bridge MAC address as soon as the master leaves.

[Sysname] undo irf mac-address persistent

# Set the domain ID of the IRF fabric to 1.

[Sysname] irf domain 1

# Create VLAN 3, and add Ten-GigabitEthernet 1/0/2, Ten-GigabitEthernet 2/0/1,

Ten-GigabitEthernet 3/0/2, and Ten-GigabitEthernet 4/0/1 to VLAN 3.

[Sysname] vlan 3

[Sysname-vlan3] port ten-gigabitethernet 1/0/2 ten-gigabitethernet 2/0/1

ten-gigabitethernet 3/0/2 ten-gigabitethernet 4/0/1

[Sysname-vlan3] quit

# Create VLAN-interface 3, assign it an IPv6 address, and enable ND MAD on the interface.

[Sysname] interface vlan-interface 3

[Sysname-Vlan-interface3] ipv6 address 2001::1 64

[Sysname-Vlan-interface3] mad nd enable

You need to assign a domain ID (range: 0-4294967295)

[Current domain is: 1]:

The assigned

Configure Device E as the intermediate device:

CAUTION:

If the intermediate device is in an IRF fabric, you must assign this fabric a different domain ID than the ND

MAD-enabled fabric.

# Enable the spanning tree feature globally on Device E to prevent loops.

<DeviceE> system-view

[DeviceE] stp global enable

domain ID is: 1

Table of Contents

Show Quick Links

Hide quick links:

Table of Contents

This manual is also suitable for:

5920 series

HP 5900 Series Configuration Manual page 53

Hide quick links:

Related Manuals for HP 5900 Series

Related Products for HP 5900 Series

This manual is also suitable for:

Table of Contents